0102030405
2 Port Panel Antenna 1550-1620/1160-1280MHz rf power module antenna
Specification
|
Electrical Specifications |
||
|
Model |
TDJ-131215H65D15 |
|
|
Frequency range (MHz) |
1550-1620 |
1160-1280 |
|
Polarization |
Vertical |
|
|
Gain（dBi） |
15±0.5 |
|
|
Beam width-3dB（°） |
H:65 V:15 |
|
|
Front-to-back ratio（dB） |
≥23 |
|
|
Isolation（dB） |
≥25 |
|
|
Input Impedance（Ω） |
50 |
|
|
VSWR |
≤1.6 |
|
|
Lightning protection |
DC Ground |
|
|
Mechanical Specifications |
||
|
Input connector type |
2*N Female |
|
|
Dimensions (mm) |
1000x280x125 |
|
|
Antenna weight (kg) |
4 |
|
|
Radome material |
UPVC |
|
|
Operational Humidity(％) |
10-95 |
|
|
Mechanical tilt（°） |
0～15 |
|
|
Operating temperature（°c） |
-30～65 |
|
|
Rated Wind Velocity（m/s） |
36.9 |
|
|
Mounting hardware（mm） |
￠35～￠75 |
|
Horizontal Pattern Vertical Pattern
Antenna Installation Instructions
Install as the pictures below
Installation Steps
Please following the steps below: place the antenna on the pole, and adjust the inclination of the antenna, then fasten the screw to the screw nut. The final structure is just like the pictures above.
1、Unscrew and take the screw nuts, the spring washer and flat washer of the saw tooth clamps on the upper and lower sides of the antenna down,then remove the outer saw tooth clamp.Put the end of the antenna with connectors downwards.Then attach the saw tooth clamps to the pole whose outer diameter is ￠35~￠90mm ,and place the M10 screws through the saw tooth clamps.Lastly, put on the flat washer and spring washer and screw the nuts tightly afterwards.
2、Take down the connector cover of the antenna,connect the antenna connectors and make sure that you have sealed the connections well.
3、Loosen the bolts that connect the two struts and adjust the inclination of the antenna to the proper position to receive the best signal. At last screw all the nuts tightly.